Basic Tutorial:Configuration Instructions for Lucky miner LV06 - LV08 (Mobile Phone Version)

1. Kit List

1.1One Lucky miner LV05 host;

1.2 One 100 - 240V wide - voltage adapter.

2. Connect to the Power Supply

2.1 Insert the AC plug of the adapter into a power strip or power socket (overseas users need to prepare their own corresponding power adapters).
2.2 Insert the DC plug into the power port (DC port) of the LV05.

3. Connect to the Network (WiFi)

Wait for about 1 minute, and then find the network named "Lucky_****" in the WiFi list on your mobile phone.

4. Mining Configuration

4.1 Select the WiFi name ("Lucky_****") that appears in step 3.
4.2 Jump to the mobile phone configuration interface.

4.3 Select "Settings" to perform the mining configuration (refer to the prompts as shown in the figure below).

4.3.1 Configure the mining parameters properly.

4.3.2 Click "Save" to save the parameters.

4.3.3 Click "Restart".

5. Check the Operating Status (Local End)

5.1 Web - End Status

5.2 Device - End Status

6. Change the Configuration

6.1 Turn off the router and wait for about 1 minute, then repeat steps 3 - 4.
6.2 Move the device outside the WiFi signal range of the previous operation.

7. Check the Mining Pool - End Status

7.1 For SOLO mining pools, you can check through the wallet address (supported by some mining pools). For example, visit mining pool websites like http://www.vkbit.com.

7.2 Some mining pools support checking with an account. You need to register a mining pool account and view through the observer link.

7.3 For some mining pools, it is impossible to access their websites in China, so you cannot view the real - time situation of the mining pool - end. However, this does not affect the income distribution as long as the local - end status is normal.

8. Appendix (Mining Pools)